Kernel driver `w83627hf.o'
=========================

Status: Beta.

Supported chips:
  * Winbond W83627HF (ISA accesses ONLY)
    Prefix 'w83627hf'
    Addresses scanned: ISA address retrieved from Super I/O registers
    Datasheet: Publicly available at the Winbond website
  * Winbond W83627THF (ISA accesses ONLY)
    Prefix 'w83627thf'
    Addresses scanned: ISA address retrieved from Super I/O registers
    Datasheet: Publicly available at the Winbond website
  * Winbond W83697HF (ISA accesses ONLY)
    Prefix 'w83697hf'
    Addresses scanned: ISA address retrieved from Super I/O registers
    Datasheet: Publicly available at the Winbond website

Authors: Frodo Looijaard <frodol@dds.nl>, Philip Edelbrock <phil@netroedge.com>,
         and Mark Studebaker <mdsxyz123@yahoo.com>


Module Parameters
-----------------

* force: short array (min = 1, max = 48)
  List of adapter,address pairs to boldly assume to be present
* force_addr: int
  Program the Super I/O register for the sensors ISA base address
* force_w83627hf: short array (min = 1, max = 48)
  List of adapter,address pairs which are unquestionably assumed to contain
  a `w83781d' chip
* force_w83627thf:
  Ditto
* force_w83697hf:
  Ditto
* ignore: short array (min = 1, max = 48)
  List of adapter,address pairs not to scan
* ignore_range: short array (min = 1, max = 48)
  List of adapter,start-addr,end-addr triples not to scan
* probe: short array (min = 1, max = 48)
  List of adapter,address pairs to scan additionally
* probe_range: short array (min = 1, max = 48)
  List of adapter,start-addr,end-addr triples to scan additionally
* init=[0,1] (default 1)
  Use 'init=0' to bypass initializing the chip.
  Try this if your computer crashes when you load the module.


Description
-----------

This driver implements support for ISA accesses *only* for
the Winbond W83627HF, W83627THF, and W83697HF Super I/O chips.
We will refer to them collectively as Winbond chips.

This driver supports ISA accesses, which should be more reliable
than i2c accesses. Also, for Tyan boards which contain both a
Super I/O chip and a second i2c-only Winbond chip (often a W83782D),
using this driver will avoid i2c address conflicts and complex
initialization that were required in the w83781d driver
(lm_sensors releases 2.7.0 and earlier).

If you really want i2c accesses for these Super I/O chips,
use the w83781d driver. However this is not the preferred method
now that this ISA driver has been developed.

For further information on this driver, /proc values, etc.
see the w83781d driver documentation.


Author/Maintainer
-----------------
Mark D. Studebaker (mdsxyz123@yahoo.com).
Derived from the w83781d driver.
Send requests to the sensors@stimpy.netroedge.com mailing list.
