jabawok.net scratchpad

User Tools

Site Tools

Trace:
genkernel-hyperv-notes

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
genkernel-hyperv-notes [2019/08/07 10:05] – snarggenkernel-hyperv-notes [2021/01/15 15:39] (current) – snarg
Line 1: Line 1:
 +As tested at 202101, the --hyperv flag now works on genkernel, so the below is completely un-needed, but kept for historical purposes. Currently all you need is genkernel --hyperv all
 +
 + --disklabel is now built into genkernel as default so not needed as a parameter
 +
 +---------------------------
 As at 201804 (and 201908 - updated), genkernel cannot create either a kernel or an initramfs that will boot under hyperv. The ata_piix module ignores the ata emulation support ( with kernel message "Hyper-V Virtual Machine detected, ATA device ignore set" ) if CONFIG_HYPERV_STORAGE is set. Therefore either dont set it to use ata_piix, or make sure the resulting module (hv_storvsc) actually loads. As at 201804 (and 201908 - updated), genkernel cannot create either a kernel or an initramfs that will boot under hyperv. The ata_piix module ignores the ata emulation support ( with kernel message "Hyper-V Virtual Machine detected, ATA device ignore set" ) if CONFIG_HYPERV_STORAGE is set. Therefore either dont set it to use ata_piix, or make sure the resulting module (hv_storvsc) actually loads.
  
genkernel-hyperv-notes.1565143546.txt.gz · Last modified: 2019/08/07 10:05 by snarg